Westermo MRI-128-F4G-PSE24 - Manual (Page 102)

98
802.1Q Tunnel =
access
802.1Q Tunnel Uplink
= uplink
access Set the interface as an access port of IEEE
802.1Q tunnel mode
uplink Set the interface as an uplink port of IEEE
802.1Q tunnel mode
Port Accept Frame
Type
Switch(config)# inter fa1
Switch(config-if)# acceptable frame type all
any kind of frame type is accepted!
Switch(config-if)# acceptable frame type
vlantaggedonly
only vlan-tag frame is accepted!
Ingress Filtering (for
fast Ethernet port 1)
Switch(config)# interface fa1
Switch(config-if)# ingress filtering enable
ingress filtering enable
Switch(config-if)# ingress filtering disable
ingress filtering disable
Egress rule –
Untagged (for VLAN
2)
Switch(config-if)# switchport access vlan 2
switchport access vlan - success
Egress rule – Tagged
(for VLAN 2) Switch(config-if)# switchport trunk allowed vlan add 2
Display – Port Ingress
Rule (PVID, Ingress
Filtering, Acceptable
Frame Type)
Switch# show interface fa1
Interface fastethernet1
Administrative Status : Enable
Operating Status : Not Connected
Duplex : Auto
Speed : Auto
Flow Control :off
Default Port VLAN ID: 2
Ingress Filtering : Disabled
Acceptable Frame Type : All
Port Security : Disabled
Auto Negotiation : Enable
Loopback Mode : None
STP Status: disabled
Default CoS Value for untagged packets is 0.
Mdix mode is Auto.
Medium mode is Copper.