Westermo MRI-128-F4G-PSE24 - Manual (Page 139)

135
Click Initialize Selected to set the authorize state of selected port to initialize
status.
Click Reauthenticate Selected to send EAP Request to supplicant to request
reauthentication.
Click Default Selected to reset the configurable 802.1x parameters of selected port
to the default values.
802.1X Port Status
The user can observe the port status for Port control, Authorize Status, Authorized
Supplicant and Oper Control Direction on each port.
4.11.3 CLI Commands of the Security
Command Lines of the Security configuration
Feature Command Line
Port Security
Add MAC Switch(config)# mac-address-table static
0007.7c01.0101 vlan 1 interface fa1
mac-address-table unicast static set ok!
Port Security Switch(config)# interface fa1
Switch(config-if)# switchport port-security
Disables new MAC addresses learning and aging
activities!
Note: Rule: Add the static MAC, VLAN and Port
binding first, then enable the port security to
stop new MAC learning.