Verilink QUAD/IMUX (880-502392-001) Product Manual - Manual (Page 89)

Verilink QUAD/IMUX User Manual Index-3
Performance Report Message 4-4
Command/Response 4-5
PLB BOP, Payload Loopback 4-5
Poll Mode option 4-5
PRM C/R, see also Performance Report Message
Command/Response 4-5
PRM, see also Performance Report Message 4-4
Q
QUAD 2164
administration menu 3-10, 4-12
Card 1 parameter 3-13, 4-15
Card 2 parameter 3-13, 4-15
Configuration Menu 4-4
front panels 1-8
query firmware 3-11, 4-13
R
RAI
Rx/Tx parameter 5-4, 5-5
Read Community string 3-11, 4-12
Ref Clk Phase parameter 3-13, 4-15
reset card 3-11, 4-13
Reset Registers
parameter 5-4, 5-6
Reset Test Counter
parameter 6-2
Restore State
parameter 5-4, 5-6
restoring defaults 3-4
RI, see also Ring Indicator 3-13, 4-15
Rx Clk Phase parameter 3-12, 4-15
S
Send LLB BOP parameter 6-2
Send PLB BOP parameter 6-2
Send/Rec LLB BOP 4-5
Send/Rec PLB BOP 4-5
SES
Count parameter 5-8
errors 5-6
Exceeded parameter 5-8
threshold 3-6, 4-6
Severely Errored Sec-Line parameter 5-6
Severely Errored Seconds 5-4, 5-8
parameter 5-6
signalling bits 5-10, 6-4
SLIP
address 3-11, 4-12
sub-net mask 3-11, 4-12
status reporting 6-1
sub-net mask 3-10, 4-12
switch over once
option 3-11, 4-13
switch over permanent
option 3-11, 4-13
System uptime 3-11, 4-12
T
TERM 4-5
Test Error
Counter parameter 6-2
Test Pattern
parameter 6-2, 6-3
Threshold Alert Status parameter 5-4, 5-6
Threshold Status
parameters 5-7
time of day 3-6
timing 3-4
Timing Options 3-6
TM, see also Transmit protocol 3-14, 4-16
TOD, see also time of day 3-6
Trap Addresses 3-11, 4-12
Tx Clk Phase parameter 3-12, 4-15
U
UAS
Count parameter 5-8
Exceeded parameter 5-8
threshold 3-6
Unavailable Seconds 5-8
parameter 5-6
W
Write Community string 3-11, 4-12
write file to flash
option 3-11, 4-13