Second remote site, Second remote site -19 – Verilink QUAD/IMUX (880-502392-001) Product Manual User Manual

Page 37

Quick Set-Up

Verilink QUAD/IMUX User Manual

2-19

22. Press E

NTER

to refresh the display of the IMUX 2160

Configuration Menu. A column of

XXXX characters should appear

under each T1 circuit which is being used by the IMUX 2160.
See

Figure 2-16

Figure 2-16 IMUX 2160 Using Four T1 Circuits

Second Remote

Site

23. Repeat steps 1 through 22 of this procedure at the second

remote site. Because the second site uses eight T1 circuits
instead of four—at the IMUX 2160 Configuration Menu, after
using the “Q1” command as in Step 19—also type “Q2” and
enter “1,2,3,4” to select the T1 circuits on the second QUAD
2164.

-- IMUX 2160 CONFIGURATION MENU --

L) Line Type : T1 1) DSR NO

L) Line Type : T1 1) DSR NO
C) Channel Rate: 64K 2) CTS NO

C) Channel Rate: 64K 2) CTS NO

C) Channel Rate: 64K 2) CTS NO
R) Rx Clk Phase: INVERT 3) DCD YES

R) Rx Clk Phase: INVERT 3) DCD YES

R) Rx Clk Phase: INVERT 3) DCD YES
T) Tx Clk Phase: INVERT 4) RI YES

T) Tx Clk Phase: INVERT 4) RI YES

T) Tx Clk Phase: INVERT 4) RI YES
F) Ref Clk Phase: NORMAL 5) TM NO

F) Ref Clk Phase: NORMAL 5) TM NO

F) Ref Clk Phase: NORMAL 5) TM NO
H) DTE Handshake: AUTOMATIC

H) DTE Handshake: AUTOMATIC

H) DTE Handshake: AUTOMATIC
DTE Type: V.35

DTE Type: V.35

DTE Type: V.35
Q1) Quad Card 1: 1 2 3 4

Q1) Quad Card 1: 1 2 3 4

Q1) Quad Card 1: 1 2 3 4
Q2) Quad Card 2:

Q2) Quad Card 2:

1 2 3 4 5 6 7 8

1 2 3 4 5 6 7 8
Lines Equipped: X X X X

Lines Equipped: X X X X

Lines Equipped: X X X X
Lines Active: X X X X

Lines Active: X X X X

Lines Active: X X X X
Frame Status: X X X X

Frame Status: X X X X

Frame Status: X X X X
CTS Status: X X X X

CTS Status: X X X X

CTS Status: X X X X
CRC Status:

CRC Status:

CRC Status:
Far CRC Status:

Far CRC Status:

X) main menu

[1,2] IMUX 2160 >