Configure the imux 2160s, Configure the imux 2160s -11 – Verilink QUAD/IMUX (880-502392-001) Product Manual User Manual

Page 29

Quick Set-Up

Verilink QUAD/IMUX User Manual

2-11

23. Use the “I1”, “I2”, “I3”, and “I4” commands to set the Clear

Interval to 30 seconds. Now, if a T1 fails, the IMUX 2160 will
stop using that T1 (as it always does) and only resume using it
when the T1 failure has been resolved for 30 seconds. Type
“X” twice to return to the Main Menu for the QUAD 2164.

24. Repeat

Step 19

through

Step 23

for the two remaining QUAD

2164 modules in slots 7 and 8.

Configure the

IMUX 2160s

1. From the Main Menu use the “S” command to navigate to slot 4

where the first IMUX 2160 resides. Use the “C” command to
access the IMUX 2160 Configuration Menu.

Figure 2-10 IMUX 2160 Configuration Menu

2. The

Line Type

Line Type of T1 is correct for this example. 64K is the

correct setting for

Channel Rate

Channel Rate when a B8ZS T1 is used.

NOTE: When

Rx Clock

Rx Clock is set to “INVERT” the clock signal is actually

normal. When

Rx Clock

Rx Clock is set to “NORMAL” the clock signal is

actually inverted. When

Tx Clock

Tx Clock is set to “INVERT” the clock

signal is actually normal. When

Tx Clock

Tx Clock is set to “NORMAL”

the clock is actually inverted.

-- IMUX 2160 CONFIGURATION MENU --

FW Rev : 1.28

FW Rev : 1.28
L) Line Type : T1 DSR) NO

L) Line Type : T1 DSR) NO

L) Line Type : T1 DSR) NO
C) Channel Rate: 64K CTS) NO

C) Channel Rate: 64K CTS) NO

C) Channel Rate: 64K CTS) NO
R) Rx Clk Phase: INVERT DCD) YES

R) Rx Clk Phase: INVERT DCD) YES

R) Rx Clk Phase: INVERT DCD) YES
T) Tx Clk Phase: INVERT TM) NO

T) Tx Clk Phase: INVERT TM) NO

T) Tx Clk Phase: INVERT TM) NO
F) Ref Clk Phase: NORMAL

F) Ref Clk Phase: NORMAL

F) Ref Clk Phase: NORMAL
H) DTE Handshake: AUTOMATIC

H) DTE Handshake: AUTOMATIC

H) DTE Handshake: AUTOMATIC
DTE Type: V.35

DTE Type: V.35

DTE Type: V.35
Q1) Quad Card 1:

Q1) Quad Card 1:

Q1) Quad Card 1:
Q2) Quad Card 2:

Q2) Quad Card 2:

1 2 3 4 5 6 7 8

1 2 3 4 5 6 7 8
Lines Equipped:

Lines Equipped:

Lines Equipped:
Lines Active:

Lines Active:

Lines Active:
Frame Sync:

Frame Sync:

Frame Sync:
CTS Received:

CTS Received:

CTS Received:
CRC Error:

CRC Error:

CRC Error:
Far CRC Error:

Far CRC Error:

X) main menu

A [0.0.0.206] [1,4] IMUX 2160 >