Verilink DIDCSU 2912 (880-502646-001) Product Manual User Manual
Page 89
DIDCSU E1 Version
Verilink DIDCSU 2912 User Manual
4-17
Table 4-8
E1 Port Diagnostics Menu
Command
Description
Options
Ln
Line Loopback (LLB): A loopback in the local CSU which faces the E1
network port.
Use this option to allow a network technician to test from a remote site
(or from within the telco network). With Line Loopbacks, incoming
signals are looped around and sent back toward the network. The
service provider or far end technician can then determine if the E1 line
is good.
1) DEACTIVATE
2) ACTIVATE
Pn
Payload Loopback (PLB): A loopback in the local CSU which faces the E1
network port. A Payload Loopback tests more of the CSU hardware than
a Line Loopback.
Use this option to test the CSU from the far-end node. In this case, the
data goes through the DIDCSU framer before it is looped back toward
the network
1) DEACTIVATE
2) ACTIVATE
Rn
Local Loopback (RLB): A loopback near the E1 network port which faces
the local CSU. DTE connected behind the DIDCSU should receive its own
data stream.
Use this option if you want to test the data interface. Also known as a
Repeater Loopback, the data sent from the data equipment passes
through the CSU up to the network interface and back to the equipment
without passing through the E1 line.
1) DEACTIVATE
2) ACTIVATE
In
Send Inband Loop Code: Sends a request for a remote CSU loop in the
timeslots of the selected network port.
1) DEACTIVATE
2) ACTIVATE
En
Reset Test Counter: This option resets the test counter to 0. The
counter is automatically reset when changing patterns.
DIDCS
Framer
CPE
E1
DIDCS
Framer
CPE
E1
DIDCS
Framer
CPE
E1