Verilink DIDCSU 2912 (880-502646-001) Product Manual - Manual (Page 24)

DIDCSU 2912 Quick Set-Up
2-6 Verilink DIDCSU 2912 User Manual
Allow Network
Originated Loops
18. Type “NL1”, then “Y” to allow network initiated loops on Net
Port 1. Type “NL2”, then “Y” to allow network initiated loops
on Net Port 2.
Set Alarm Declare
Time to 2 Seconds
19. Type “A1”, then “2” to set the number of elapsed seconds
before declaring an alarm condition for Net Port 1. Type “A2”,
then “2” to set the number of elapsed seconds before
declaring an alarm condition for Net Port 2.
Disable Facilities
Data Link
20. We do not need FDL connectivity to the far-end. Type “DL1”,
then “N” to disable FDL for Net Port 1. Type “DL2”, then “N” to
disable FDL for Net Port 2.
Select no DS0 for
Inband
Management
21. “S1” and “S2” are not used because no inband timeslot (DS0) is
reserved for management in this example.
Disable Inband
Management
22. Type “E1”, then “2” to disable inband for both ports.
Timing Options 23. From the Configuration Menu, select “T” for the Timing
Options submenu.
Figure 2-6 Timing Options
24. Type “R”, then “Y”, and press E NTER to refresh the screen.
Observe that some of the menu items change depending on
whether the
Receive clock from shelf option is YES, or NO.
Use the PC, PS, PA, SC, SS, SA, TC, TS and TA commands to
configure the DIDCSU as shown in
Figure 2-6 .
25. Use “X” to exit to the T1 Port Configuration Menu. Then use
“X ” ” ” ” again to exit to the Configuration Menu.
-- DIDCSU 2912 CONFIGURATION MENU (TIMING OPTIONS)-- -- DIDCSU 2912 CONFIGURATION MENU (TIMING OPTIONS)-- -- DIDCSU 2912 CONFIGURATION MENU (TIMING OPTIONS)-- -- DIDCSU 2912 CONFIGURATION MENU (TIMING OPTIONS)--
Current shelf timing source: Card 2, NET 1 (PRIMARY) Current shelf timing source: Card 2, NET 1 (PRIMARY) Current shelf timing source: Card 2, NET 1 (PRIMARY) Current shelf timing source: Card 2, NET 1 (PRIMARY)
Source Slot Number Synchronization Auto Restore Source Slot Number Synchronization Auto Restore Source Slot Number Synchronization Auto Restore Source Slot Number Synchronization Auto Restore
PRIMARY PC) 2 PS) NET 1 PA) YES PRIMARY PC) 2 PS) NET 1 PA) YES PRIMARY PC) 2 PS) NET 1 PA) YES PRIMARY PC) 2 PS) NET 1 PA) YES
SECONDARY SC) 2 SS) NET 2 SA) YES SECONDARY SC) 2 SS) NET 2 SA) YES SECONDARY SC) 2 SS) NET 2 SA) YES SECONDARY SC) 2 SS) NET 2 SA) YES
TERTIARY TC) 2 TS) INTERNAL TA) YES TERTIARY TC) 2 TS) INTERNAL TA) YES TERTIARY TC) 2 TS) INTERNAL TA) YES TERTIARY TC) 2 TS) INTERNAL TA) YES
R) Receive clock from shelf: YES R) Receive clock from shelf: YES R) Receive clock from shelf: YES R) Receive clock from shelf: YES
X) exit this screen
X) exit this screen X) exit this screen X) exit this screen