beautypg.com

Phone connection, Business telephones, Single line phones – Skutch Electronics BA-1000-A Technical Reference Guide User Manual

Page 7: Order a phone jack, Connect it and power up, Diagnostic test

background image

Version 6.XX

Page 7

Phone Connection

The system’s telephone line requirements are the same as

a standard telephone. Its connection to the telephone line is the
same as any NORMAL single line telephone that you could buy
at any department store.

Business Telephones

This system is not compatible with modular jacks used for

multi-line ELECTRONIC PHONE SYSTEMS. To connect the
SYSTEM to this type of phone system, an RJ-11 jack must be
ordered from your local telephone company. It should be noted
that when the BA-1000-A is used, the line indicator lights on the
phone system will NOT show the line as being used. We also
recommend installing our T-70 Busy Out modules with this unit,
so that no calls go “Ring no answer”.

Single Line Phones

If you have a single line phone it is probably connected to

a small modular jack. Simply unplug the phone and plug the
system in. If you wish to have both the phone and the system
connected at the same time you can plug the phone into the
PHONE jack on the back of the BA-1000-A.

Order A Phone Jack

If you need to order a jack from the telephone company,

you will need the following information:

FCC No: AP494N-64812-MA-E

RINGER EQ.:0.0B

USOC No (Jack type) RJ-11, RJ-12, or RJ-13 (See

telephone connection)

* * *

Connect it and Power Up

Connect our phone cord from the unit, the jack labeled

LINE, to your phone line jack on the wall. It will only work on
a standard phone line, like your house phone line or a jack your
FAX machine plugs in to.

Insert the CF Card into the back of the unit; the system

MUST have the CF Card in the unit at all times to operate.

Connect the supplied POWER ADAPTER to the

POWER jack on the rear panel of the BA-1000-A. This
MUST be done before the POWER ADAPTER is connected
to 115VAC power.

Now plug the POWER ADAPTER to a 115VAC 60Hz

power outlet.

* * *

Diagnostic Test

Every time the BA-1000-A is powered up, it performs a

series of diagnostic tests as follows:

The display shows the initial splash screen:

Copyright 1999
Skutch Elec, Inc

Then it sets up the phone line circuits, showing:

- Initializing –
Phone line CODEC

Then it sets up the mic circuits, showing:

- Initializing –
Microphone CODEC

Then the system will calibrate the microphone input.

Make sure the no audio source or microphone is PLUGGED in
while the system says:

Remove MIC While
Calibrating!

After 8 seconds, the system will show:

Now POWERING UP
primary systems.

Then the system will show:

- Initializing -
-- IDE Drive—

Then it will test the IDE drive and show the following:

Testing IDE Disk
– Please Wait -

Then it will test all the files on the system, showing:

-Testing Files-
- Please Wait -

The system will update the number in the top right to

show the current file being tested. When all tests are done the
system will show the following:

>System On Line<
100% Functional!

Then the system will put you at the MENU, as follows:

0-Idle-v6.10--Th
05/31/07 08:00am