Skutch Electronics BA-1000-A Technical Reference Guide - Manual (Page 17)

Version 6.XX Page 17
Wait 1 second.
Enter your PIN, then
# # # #
.
Wait 1 second.
Press:
0 0 0 0
to start the system to take calls.
To exit, press
* * * *
.
* * *
Call in to Change the
Default Voice Mail box
This option lets you change which Voice Mail box will get
the message (if a caller doesn’t choose a Voice Mail box). Any
Voice Mail box user can do this, but he must know his PIN.
Call the system from a standard Touch Tone telephone.
After the intro message starts to play, enter:
* 0506 # * 0506 # * 0506 # * 0506 #
Wait 1 second.
Enter your PIN, then
# # # #
.
Wait 1 second.
Press:
8 8 8 8
.
Enter the new Default Box to use for callers that don’t
select a Voice Mail box.
To exit, press
* * * *
again.
Setup Mode
Setup Mode is used to set the clock and to change various
system parameters of the BA-1000-A. It should be noted that
changing the system parameters WILL effect the operation of
the machine. You should not change any parameters that you do
not understand or it might cause a malfunction in the operation.
Call technical support if you are not sure!
Enter:
888 888 888 888
Set CURRENT Time
The first option in System Setup is to set the current time.
The display will show the following:
Set CURRENT Time
1=Change #=Next
You can press then release
1 1 1 1
to change the current time
or # to proceed to the next option. You can press then release
~ ~ ~ ~
to exit setup mode.
• Set The Current Day
If you press then release
1 1 1 1
to change the time; the
display shows:
Enter day, 1 – 7
#=Sunday
The current day will be shown in the bottom of the
display. To change the day, press then release the corresponding
number followed by
# # # #
; i.e.
1 1 1 1
for Sunday,
2 2 2 2
for Monday,
etc.
• Set The Current Date
Now the display will show:
-- Enter Date –-
# = 01/01/1980
The current date will appear in the bottom of the display.
You can enter a new date followed by
# # # #
, or just press then
release
# # # #
to keep the current date.
• Set the Current Time
Now the display will show:
-- Enter time --
- # = 12:00 pm –
The current time will appear in the bottom of the display.
You can enter a new time followed by
# # # #
, or just press then
release
# # # #
to keep the current time. You can change between
a.m./p.m. by pressing then releasing the
* * * *
.
Access Code=1234
This is the access code used to remotely retrieve messages
left on the system. The display will look as follows:
Access Code=1234
1=Change #=Next
You can press then release
1 1 1 1
to change the access code,
followed by the
# # # #
, or press then release
# # # #
to proceed to the
next option. You can press then release
~ ~ ~ ~
to exit
setup mode.
Play Only= Off
This controls Announcement Only mode. When ON, the
unit will answer the phone, play the outgoing message, and will
hang up without recording a response. The display will look as
follows:
Play Only= Off
1=Change #=Next