RLE Protocol Converter V.2.4 - Manual (Page 27)

rletech.com Protocol Converter User Guide 27
3
Configuration
3.3. Configure Network and Web Properties
Use the Configuration section of the Protocol Converter’s web interface to configure basic
device functionality. The Network and Web link displays the MAC address and allows you to
fill in the IP Address, Net Mask, Default Router (Default Gateway), Passwords, and Refresh
rate.
In the user interface, go to Configuration>Network and Web. Edit the fields appropriately.
Figure 3.8 Network and Web Configuration Screen
Option Description
IP Address The Protocol Converter is configured at the factory with a default IP
Address of 10.0.0.188. If you’d like to change the IP address, do so here.
Default: 10.0.0.188
Net (Subnet)
Mask
The Protocol Converter is configured at the factory with a default Subnet
Mask of 255.255.255.0. Edit this field as necessary.
Default: 255.255.255.0
Def (Default)
Route
The Protocol Converter is configured at the factory with a default Gateway
Route of 10.0.0.1. Edit this field as directed by your IT department.
Default: 10.0.0.1
Web
Password
Read Only
The Protocol Converter can be configured with two passwords - the read
only password allows users to access the web interface but not to edit any
of the configurable settings.
Specify an alphanumeric value up to 16 characters.
Table 3.1 Network and Web Configuration Fields