RLE LD5100 - Manual (Page 47)

www.rletech.com 47 970.484.6510
7 EIA-232 Interface
7.4. Other Main Menu Functions
The remainder of the functions available from the Main Menu of the EIA-232 interface are
described in Table 7.2.
Table 7.2 Other Main Menu Functions
Option Description
LS – Leak Status LS displays the current cable readings, including both
cable length and any present current leakage.
AR – Alarm Reset AR resets all alarm relays. This command forces all alarms
off. If an alarm condition is still present after the AR
command is executed, the alarm is reactivated. If an alarm
is still active after the AR command is executed, it will not
be re-entered in the Alarm History Log.
AH – Alarm History AH displays the Alarm History Log.
CH – Clear Alarm History CH clears the Alarm History Log.
TD – Trend Data Table TD displays the Trend Data Table, which monitors and
displays leakage current.
CT – Clear Trend Data Table CT clears all records from the Trend Data Table.
TI – Display Date/time TI displays the LD5100’s current date and time
MT ON – Measurement Trace
On
MT ON displays advanced manufacturer diagnostics of the
microprocessor.
MT OFF – Measurement
Trace Off
MT OFF turns off the display of advanced manufacturer
diagnostics of the microprocessor.
MBT – Modbus Trace On MBT shows Modbus trace.
MBS – Modbus Stats MBS shows Modbus stats.
EX – Exit EX is used to enter the Bootloader command section. The
unit will stop monitoring cable and allow firmware updates
to be loaded. To restore normal operation after updating
firmware, type RUN and press the Enter (<-|) key on the
keyboard, or power the unit off and then back on again.