RLE LD5100 - Manual (Page 16)

www.rletech.com 16 970.484.6510
1 Product Overview
1.3. Mechanical Description
The LD5100 is built with two circuit boards:
 The display board is connected to the main board with a 20 wire ribbon cable and two
power wires. The display board is mounted on the inside of the unit's door.
 The main board is mounted inside and on the back of the enclosure. A reset switch is
provided to reset the microprocessor without cycling power to the unit.
1.4. Installation
The LD5100 with LCD is a wall mounted device. Before applying power to the unit, ensure
that all connections are correct and all screw terminals are secure.
1.5. Cable Reference Map
Users may purchase a Water Leak Detection Cable Reference Map (part # FM1114) with their
LD5100. Once all the SC cable is installed, compare this reference map with the actual cable
installation. Note any discrepancies and return the map to the original author for correction.
Keep a copy for use until the updated map can be reinstalled near the control panel.
1.6. LCD User Interface
The LD5100’s LCD is a 160x160 pixel resolution backlit display with a five button keypad.
The default password for the system setup is 1234. The interface's menu structure is as
follows:
 Main Menu
– View Zones
– Cable Status
– Alarm History/Trend
– Alarm History
– Trend
– Erase Alarm History
– Erase Trend Log
 Comm Port Status
 View Map
 System Setup - Password Protected
– Leak TripPoint
– Contam TripPoint
– Leak Delay
– Contam Delay