RLE LD5100 - Manual (Page 27)

www.rletech.com 27 970.484.6510
3 Installation
Figure 3.2 Cable Installation Methods
3.3. Apply Power to the Unit
Once the SC is connected to the unit, power may be applied
A dedicated circuit breaker must be provided in the building within close proximity
to the LD5100 and be clearly marked as the disconnecting device for this unit.
The LD5100 operates between100 - 240 VAC power. An AC power supply should be run to
the location of the unit. Before applying power to the unit, make sure the AC breaker switch is
turned off.
Once the power is turned off, strip the end of the AC supply so the three wires inside are
exposed. Strip the end of the line and neutral wires and feed the ends to the power supply
inside the LD5100 enclosure. The two power wires must now be inserted into the terminal
block in the lower right corner of the enclosure (Power Supply TB1). As indicated in the
enclosure, the line power wire is positioned on the center side of the terminal block (Line).
The neutral wire is placed into the opening on the left side of the terminal block (Neut). The
earth ground line is placed the right side of the terminal block (Gnd).
W ARNING