QuickLabel 200 Kiaro! - Manual (Page 94)

Kiaro! 200 Maintenance Utility
80 Kiaro! 200 User Guide
Adjusting the Top-of-Form Threshold
If any of the following errors occur while using reflective mark media, you may need
to calibrate the top-of-form sensor threshold. The following table describes the types
of adjustments needed for each error condition.
Note: Before adjusting the top-of-form threshold, verify that your media has been loaded and
configured correctly.
If you have already adjusted the top-of-form threshold for your reflective mark media,
and you are replacing a reflective mark media roll with an identical roll, repeating this
adjustment is not necessary.
1 Launch the Kiaro! 200 Maintenance Utility.
From the Windows Start Menu, choose
Start > All Programs > QuickLabel
Kiaro! 200 > Kiaro! 200 Maintenance Utility . A language and printer prompt will
open.
Select a display language and the Kiaro! 200 printer you want to connect to.
Choose
OK .
2 Choose the Adjustments tab.
Error # Error Name
Sensor Adjustment
Adjust-
ment Value Internal Cutter
1002 No paper Increase NA +0.2V
1102 Paper length is too short Increase NA +0.2V
1104 Paper length is too short NA Increase +0.2V
1301 Paper jam occurred Decrease NA -0.2V
1302 Paper jam occurred Decrease NA -0.2V
1304 Paper jam occurred NA Increase +0.2V
1305 Paper jam occurred NA Decrease -0.2V
1306 Paper jam occurred NA Increase +0.2V
130C Paper jam occurred Increase NA +0.2V
1402 Gap/Mark width error Decrease NA -0.2V
1403 Gap/Mark width error Increase NA +0.2V