QuickLabel 200 Kiaro! User Manual
Page 31
Quick Start Guide
Kiaro! 200 User Guide
17
3
Use the driver installation wizard to install the driver. Refer to the following
information during this process.
•
Choose the Ethernet connection method when prompted.
•
Allow the installer to access the network if prompted.
•
Choose the Kiaro! 200 printer in the printer list when prompted. Alternately,
you can choose to find a specific printer by IP address or MAC address.
•
Configure the printer for DHCP or a static IP address.
Ensure the printer has been in the “Ready” state for at least 30 seconds before
attempting to connect via DHCP or static IP address. Additionally, if you
change the selection from static IP address to DHCP, wait at least 30 seconds
before proceeding to allow the printer to establish DHCP communication.
•
Select an installation location for the Kiaro! 200 Maintenance Utility when
prompted.
Choose Finish in the installation wizard after successfully installing the Kiaro! 200
Maintenance Utility and driver.