QuickLabel 200 Kiaro! - Manual (Page 144)

Safety Warnings and Precautions
130 Kiaro! 200 User Guide
• Never remove the cover from the printer. This could cause a serious electrical
shock.
• It is dangerous to put your fingers deep inside the ink cartridge boxes. There are
pin-sharp parts which may hurt you or alternatively you may cause damage that
will lead to breakdown.
• Keep children from touching the power cord, internal parts of the printer when it
is open, and moving parts inside the printer (gears, belts, rollers, and electrical
components). This could cause personal injury or damage the printer.
• Labels printed with this printer should not directly be stuck on food such as fruits
and vegetables. They should be stuck on the plastic wrap over the food.
Important
• To prevent machine failures, do not open the ink tank door or maintenance
cartridge exchange door, do not turn off the printer, and do not remove the power
plug from the outlet while the printer is printing. If you do so, the print head
protection function is not performed properly, resulting in a machine failure or ink
leakage which can soil your clothes and the surrounding area.
• Do not apply excessive force or strong shock to the upper unit. Doing so can result
in a machine failure or impair printer quality. Be sure to open/close the upper unit
slowly.
• Do not place the printer close to TV, radio receiver or loudspeakers, etc. The
magnetic field produced may cause the printer to malfunction, or the printer may
interfere with TV/radio reception.
• Printed labels and ink can discolor due to ultraviolet rays and ozone.
Moving the Printer
Warning
• Call the dealer for advice before you ship the printer a long distance or move the
printer by car or truck where it may be subjected to shock and vibration. Moving
the printer without the proper preparation could subject it to shocks and
vibrations which could damage the printer and cause a fire.
Caution
• Before moving the printer, use the appropriate procedures to drain ink from the
printhead or entire print system. See Preparing for Moving and Preparing for
Shipping.
• Before you move the printer to another location in the same building, disconnect
the power cord and make sure that all other cables are disconnected.
• The printer can weigh up to 170 pounds (77 kilograms). Three persons are required
to lift the printer. Lift only by the black frame on the bottom of the printer. Do not
grasp any other part of the printer to lift it. Do not lift the unit by the print engine.