OpenEye CM-511 - Manual (Page 46)

46
SCHEDULE
The schedule function enables users to program a preset point or function (Tour/Auto Scan/Pattern)
automatically to perform in a specific period of time.
Switch
Select to enable or to disable the schedule function.
Point
Users are allowed to arrange 32 sets of schedule points, i.e. each set of schedule points can be assigned
one kind of schedule mode.
Hour / Minute
This is used to set up the time to execute each schedule point.
Mode
This is used to set up the schedule function of the selected schedule point; the options are listed as
follows.
NONE - No action will be executed for the schedule if the item is selected.
PRESET - Users can select the PRESET mode as an action carried out in a schedule point.
TOUR - Users can select the TOUR mode as an action carried out in a schedule point.
AUTOSCAN - Users can select the AUTOSCAN mode as an action carried out in a schedule point.
PATTERN - Users can select the PATTERN mode as an action carried out in a schedule point.
IR FUNC. (IR Function) - If select the IR function mode, the AUTO IR FUNCTION will be activated for a
schedule point.
Schedule Reset
Select to reset the entire schedule.
Exit
Exit the SCHEDULE menu and go back to the MAIN PAGE 3.