OpenEye CM-511 - Manual (Page 32)

32
Speed by Zoom
If the item is set to , the pan/tilt speed will be automatically adjusted by internal algorithm when zooming.
The larger zoom ratio leads to the lower rotating speed.
Auto Cali. (Auto Calibration)
There are one horizontal point and one vertical infrared rays check points in each dome. During installation or
maintenance, the dome camera’s position may be moved. Therefore, the relative distance between the original
set point and the check point will be changed. If the Auto Calibration function is enabled, the dome will
automatically detect the matter and reset the horizontal point back to the original position.
System Reset
System Reset - Select this item for system restart. The system will not return to default settings.
Default System - Select this item to return to default settings.
Exit
Exit the TELEMETRY CTRL MENU and go back to the MAIN PAGE 1.Then go to the MAIN PAGE 2 to
carry on setting other functions.
ID DISPLAY
Press the direction key down to change the MAIN MENU page from 1 to 2, and then the menu item DISPLAY> will be shown on the top. Users are allowed to choose whether the dome ID will be displayed on
screen for identifying the domes. For more information, please refer to Dome ID Setting.
On - Display the ID address of the selected dome on the right bottom of the screen.
Off - Hide the ID address of the selected dome.