OpenEye CM-145 - Manual

General Specifi cations
Model CM-145 CM-145H
Image Sensor 1/3 inch SONY IT CCD
Imaging DSP Sony HQ1
IP Rating IP66
Type / Format NTSC
Wide Dynamic Range No
Minimum Illumination 0.3 Lux (Normal) / 0 Lux (IR LED)
Day / Night IR Emitting DN
Horizontal TVL 550 TVL
Service Monitor Jack Yes (RCA)
S/N Ratio > 50dB (AGC Off)
Focal Length 4.0 mm
Iris Control ELC
Synchronization Internal
Video Output 1.0Vpp, 75Ω, Composite
White Balance Auto
Auto White Balance Range 2100K ~ 10000K
Backlight Compensation On / Off
Auto Gain Control On / Off
Operating Temperature 14°F ~ 113°F (-10°C ~ 45°C) -22°F * ~ 113°F (-30°C ~ 45°C)
Heater No Yes
Power Consumption 3 W Normal / 5 W IR LED 13 W Max Normal / 15 W IR LED
Rated Amperature 0.4A (12vDC) / 0.3A (24vAC) 0.8 A
Input Voltage 12vDC / 24vAC (±10%) 24vAC
IR Range Up to 50 ft (15 m)
IR LED 24 (850nm / 30º)
Weight 1.86 lbs (0.84 kg)
Dimensions Dome
Housing
ø3.9” (100 mm) x H: >1.86” (47.15 mm)
ø5.71” (145 mm) x H: 2.12” (53.85 mm)
Housing / Dome Cover White / Smoked
*The CM-145H has been tested to work in extreme temperatures as low as -49°F (-45°C). In
temperatures lower than -22°F (-30°C), if the CM-145H loses power, the camera requires a
ten minute warm up time and then a manual power cycle. If these steps are not followed the
camera will not produce a picture.
VANDAL PROOF OUTDOOR
IR DOME CAMERA
Installation Sheet
CM-145
CM-145H
4 mm Lens
550 TVL Resolution
Sheet
Precautions
• Do not install the camera in extreme temperature conditions. The oper-
ating temperature of the camera is between 14°F ~ 113°F (-10°C ~
45°C). Be especially carefully with ventilation under high temperatures.
• Do not install or use the camera in an environment where the humidity
is high. It can cause a poor image quality.
• Do not disassemble the camera. There are no user-serviceable parts
inside the camera.
• Do not drop the camera or subject it to physical shocks.
• When the camera is installed near wireless communication devices
that emit a strong electromagnetic fi eld, irregularities such as noise on
the monitor may appear.
INGRESS PROTECTION
In order to prevent liquid ingress the four anchors with provided seals
must be used in combination with the rubber camera housing pad (pro-
vided). If other anchors are used, adequate seals must be supplied to
offer suffi cient liquid protection from ingress. The wire grommet provided
(white) is not designed for direct exposure to liquid. If wire ingress is nec-
essary at an exposed location, such as the side port, it is recommended
to use liquid tight EMT fi ttings and conduit to prevent leaking. Consult
local codes for more information on proper installation.
• ALL FOUR ANCHOR HOLES MUST BE SEALED
• RUBBER HOUSING PAD MUST BE USED
• INCLUDED WIRE GROMMET SUPPLIED IS NOT SUFFICIENT TO
PROTECT AGAINST DIRECT LIQUID CONTACT. IT IS RECOM-
MENDED TO USE LIQUID TIGHT FITTINGS IF REQUIRED.
29749AB