OpenEye D4000 Quick Start User Manual

Ca-d4000 | camera tester quick guide

This quick operation guide is a quick reference for users to install and operate the D4000 camera tester and only provides basic information on the settings and operation. Before attempting

to connect, configure and operate the tester, please read the user manual thoroughly.

Dimensions

Connections

Powering On / Off

Charging the Battery

CA-D4000 | Camera Tester

Quick Guide

Item

Description

LAN / PoE out

Connect the LAN cable from the PoE-enabled IP

camera.

LAN / PSE in

N/A

Micro SD slot

Data storage up to 4GB.

USB

Use for firmware upgrades or external storage.

Video in

Connect to camera with BNC cable.

Video out

Connect to monitor with BNC cable.

Stylus storage slot

Use the included stylus for touch screen operation.

Power indicator

The LED is lit when the power is on.

Data TX/RX Indicator

The LED flashes when the Tester is under operation.

Light sensor

The light sensor detects environmental brightness to

automatically adjust the LCD screen brightness.

LCD screen

3.5” screen displays video and camera setup menus.

Shift/PTZ control keys

Press the arrow keys to navigate the setup icons,

items in a menu, or use the keys to control a con-

nected PTZ camera.

ESC

Press to exit a menu without saving or return to the

previous page.

Start/Enter/Snapshot

Start: Turn on the Main Power Switch, then press

this key for 3 seconds to start the tester.

Enter: Press this key to enter a sub-menu or save

setup.

Snapshot: When viewing IP camera video, press this

key for an image snapshot. Press the key and the

snapshot menu will open within 5 seconds. Tap Enter

to save the settings of the image.

Main power switch

Switch to on before pressing the Start key.

Audio out

Connect to a headset.

Audio in

Connect to a microphone.

Charging indicator

The light will stay lit while the battery is charging.

UTP cable tester

Use a network cable to connect the tester to the

CAT5 UTP terminator for detecting wiring types

(straight/corss) or errors (open, short, miswired) us-

ing the wire map displayed on the screen.

DC 12V power adapter

Connect the supplied DC adapter.

RS-485 Terminal Block

Connect the RS-485 lines to the terminal block cor-

rectly for the dome camera’s PTZ control.

Speaker

For audio output.

D4000 Tester

BNC Cable

Network Cable

Li-ion Battery

Soft Carrying Case

DC 12V Adapter

UTP Terminal Block

Quick Start Sheet

Box Contents

99.3 mm

38 mm

170 mm

To power on the IP Camera Tester:

1. Set the Main Power Slide Switch on the side to “ON” position.

2. Press the Start Key and hold for 3 seconds. The Power Indicator LED (above the

screen) will light.

3. When the Tester powers on, a loading bar will display on the screen for 10 seconds and

the Data TX/RX Indicator LED will blink.

4. The Home Screen will display within 50 seconds.

The IP Camera Tester uses a rechargeable Li-ion battery pack that takes approximately four

hours to charge, and provides the Tester with up to three hours of operating life.

To charge the battery:

1. Plug the included DC 12V adapter in the side of the Tester.

2. While the battery is charging, the charging indicator light (above the power cable) will

illuminate. When the battery is completly charged, the light will turn off.