OpenEye CM-511 - Manual (Page 36)

36
AUTOSCAN
Auto Scan refers to the motion of scanning an area horizontally so that the dome camera can catch a horizontal
view. The parameters are listed as follows.
AutoScan Line
There are four sets of Auto Scan lines built into the dome camera. Users can choose a line to execute
using LEFT/RIGHT direction keys. In addition, users are able to command the dome camera to do endless
panning by setting the start point the same as the end point.
Start Point
To set the start position of the AUTOSCAN path:
1. Move the cursor to and press while the item, , is flashing.
The item will then turn automatically.
2. Move the dome to a desired position and press to save the position as the start point; the
cursor will move to automatically. Ensure setting the end point to complete Auto
Scan setting.
Note The tilt and zoom values of the start point will be recorded and fixed for the selected Auto Scan
line.
End Point
Users are able to set the end point after the start point is defined. Pan the dome to another position and
press to save the position as the end point.