OpenEye 960H IR - Manual

960H IR
Outdoor Dome Camera
Model no:
CM-P317R
Camera Installation & Configuration
Please carefully read these instructions before using this product.
Save this document for future use.
31376AC
23221 E Knox Ave
Liberty Lake, WA 99019
1.888.542.1103
www.openeye.net
Precaution
• Do not attempt to dismantle the camera module mounted
within the dome. There are no user serviceable parts
in the camera module. Refer servicing to a qualified
professional.
• Handle the camera with care. Do not abuse the camera.
Avoid striking or shaking it. Improper handling and
storage could damage the camera.
• Do not operate the camera beyond its temperature
or power source rating. Refer to the environmental
information provided in this document.
Features
• 700TVL Resolution
• Digital Noise Reduction
• 3-axis camera
• IP67-rated
• Wide Dynamic Range
• True Day/Night
• 24IR LEDs
General Specifications
Model No. CM-P317R (Rev B)
Image Sensor 1/3” Sony CCD
IP Rating IP67 (Outdoor)
Type / Format NTSC
Wide Dynamic Range Sony True WDR
Minimum Illumination Color: 0.15 Lux
B/W: 0.05 Lux
(@ 40IRE)
Day / Night True Day / Night (IR Cut Filter)
Resolution 700TVL
Service Monitor Jack Yes
S/N Ratio >52dB (AGC Off)
Focal Length 2.8 ~ 12 mm
Iris Control Auto-Iris
Synchronization Internal / Line Lock
Video Output 1.0 Vpp 75Ω BNC Unbalanced
White Balance AWB, ATW, Manual
Auto White Balance Range 1800K ~ 10500K
Backlight Compensation HLC, BLC, Off
Auto Gain Control Yes, 6~44dB
Operating Temperature -49˚~122˚F (-45˚~50˚C)
Heater Yes
Power Consumption 7.2W (IR LED Engaged)
Input Voltage 12vDC / 24vAC
Weight 1.8 lbs (0.82kg)
Dimensions Ø: 5.925” (150.5mm) x H: 5.13” (130.5mm)
Housing / Dome Cover White / Clear
Box Contents
• Screws (x3)
• Washers (x3)
• Torx security tool
• Service monitor cable
Dimensions
Regulatory Compliance
Emissions FCC part 15, subpart B, Class A
CE: EN61000-6-4:2007
Immunity CE: EN60130-4:1995 + A1:1998 + A2:2003
FCC COMPLIANCE
This product has been tested and found to comply with the limits for a Class A
digital device pursuant to Part 15 of the FCC rules. These limits are designed to
provide reasonable protection against harmful interference when the equipment
is operated in a commercial environment. The product generates, uses, and can
radiate radio frequency energy, and, if not installed and used in accordance with
the manufacturer’s instruction manual, may cause harmful interference with radio
communications. Operation of this product in a residential area is likely to cause
harmful interference, in which case you will be required to correct the interference
at your own expense.
This device complies with Part 15 of the FCC Rules. Operation is subject to the
following two conditions:
1. This device may not cause harmful interference.
2. This device must accept any interference received, including interference
that may cause undesired operation.
These limits are designed to provide reasonable protection against harmful
interference in a non-residential installation. However, there is no guarantee that
interference will not occur in a particular installation. If this equipment does cause
harmful interference with the radio or television reception, which can be deter-
mined by turning the equipment off and on, you are encouraged to try to correct
the interference by one or more of the following measures:
1. Reorient or relocate the antenna of the radio/television receiver.
2. Increase the separation between this equipment and the radio/television
receiver.
3. Plug the equipment into a different outlet so that the equipment and the
radio/television receiver are on different power mains branch circuits.
4. Consult the dealer or an experienced radio/television technician for
additional suggestions.