OpenEye CM-511 - Manual (Page 35)

29246AC 35
TOUR
The function executes pre-positioning of the pan, tilt, zoom and focus features in a certain Tour for a camera.
Before setting this function, you must define at least two preset points.
Tour Line
There are eight sets of Tour lines built in the dome camera. Use the LEFT/RIGHT direction keys to select
a line first and then set its Tour points.
Tour Point
Up to 64 points can be specified for each Tour line. The Tour points represent order of the preset points
that the dome will automatically run. The following setup items, PRESET POSITION, SPEED and DWELL
TIME, will influence how the camera runs through each Tour point.
Preset Position
Users can assign a specific preset position to the selected Tour point with this item.
Speed
Users can set the speed of one Tour point to the next one, and the range of setup speed is from <1> to
<15>. Within the range, PAN speed varies from 10 ~ 400(degree/sec.), and TILT speed varies from 8 ~
400(degree/sec.).
Dwell Time
The DWELL TIME is the duration time that the dome will stay at a Tour point, and the range is from <0> to
<127> seconds. The dome will go to the next Tour point when the DWELL TIME expires. If the setting is
<0>, the dome will stay at this Tour point until users manually move the dome.
Run Tour
Users can command the dome camera to run the selected Tour line manually.
Exit
Select the item to exit the TOUR menu; go back to the MAIN PAGE 2 to carry on setup of Auto Scan.
Note You can execute the Tour function using the keyboard controller. Refer to the keyboard user manual
for more information.