Pattern – OpenEye CM-511 User Manual
Page 38
38
PATTERN
PATTERN is a route formed with manual operation, through adjusting the pan, tilt position, which can be stored
and recalled to execute repeatedly.
Pattern Line
You can create up to eight Pattern paths with the dome camera. Using the LEFT/RIGHT to select an
available line (1~8) and then follow the steps below to start recording the pattern path.
Record Start
To record the PATTERN path:
1. Rotate the dome camera to a desired view area (for some protocols, users may need to do it before
entering the OSD), and press
device. The percentage of the memory buffer will be displayed on the screen.
2. Pan, and tilt the dome camera to form a path.
Note
Beware of the memory size when building a Pattern path. Once the buffer percentage reaches
100%, recording of the path will stop.
Record End
The cursor will be moved to RECORD END while building the Pattern line; when the setting is completed,
press
Run Pattern
After Pattern setting is completed, select this item to execute the Pattern function.
Exit
Exit the PATTERN setup menu; go back to the MAIN PAGE 2 to carry on setup of home setting.
Note
You can execute the Pattern function using the keyboard controller. Refer to the keyboard user
manual for more information.