NavCom SF-3050 Rev.E - Manual (Page 190)

SF-3050 Product User Guide
– Rev E
E-164
Configure the NTRIP Server
Perform these steps:
1. Configure the SF-3050 to send corrections to the
caster via the modem.
2. Connect to the caster:
[NTRIPSERVER]CONNECT
3. Set RTKMODE to use the NTRIP virtual port as
the port for sending the corrections:
[RTKMODE]BASERTCM1004,,1,NTRIP,STATIC,AUTO

BASERTCM1004 indicates the type of
corrections to send.
4. Enter the following command to disconnect from
the caster:
[NTRIPSERVER]DISCONNECT
Refer to the Sapphire Technical Reference Manual
for detailed instructions on the [ECHODGPSB],
[MODEMCONFIG], [NTRIPSERVER],
[NTRIPCLIENT], [OUTPUT], and [RTKMODE]
commands.
Configure the NTRIP Client
Perform these steps:
1. Configure the SF-3050 to receive corrections from
the caster via the modem.
2. Connect to the caster:
[NTRIPCLIENT]CONNECT
3. Verify that the ECHODGPSB message indicates
that RTCM 3.0 corrections are being received.