NavCom SF-3050 Rev.E - Manual (Page 121)

SF-3050 GNSS Product User Guide
– Rev E
3-95

Positronic 9-Pin Male to Ethernet RJ45 Plug
(P/N 94-310265-3006LF). This cable is used in
the setup described below.

Y-Cable, Positronic 9-Pin Male to Ethernet RJ45
Plug & DB9S (RS-232/1PPS) (P/N 94-310272-
3006LF)

Refer to the sections above, Ethernet Cable
(Option) and Ethernet/RS-232/1PPS Y-Cable
(Option), for detailed descriptions of the cables.
Setup
This setup uses the factory default IP address of the
SF-3050:
192.168.0.2,255.255.255.0,0.0.0.0
The PC IP address is set manually in Windows.
1. Connect the Positronic 9-Pin connector of the
Ethernet cable (P/N 94-310265-3006LF) to
COM1 - LAN of the SF-3050. Connect the RJ45
plug end to the computer.
2. In Windows, right-click My Network Places and
select Properties from the pop-up menu. The
Network Connections window opens.
3. Right-click Local Area Connection (or the
equivalent) and click Properties from the pop-up
menu. The Local Area Connection window opens.
4. Click on Internet Protocol (TCP/IP). See Figure 66.
IP Address Network Mask Gateway