NavCom SF-3050 Rev.E - Manual (Page 187)

SF-3050 GNSS Product User Guide
– Rev E
D-161
D ....................... Event Input Configuration
Figure 85 details the wiring of the supplied Event
cable assembly. NavCom part number P/N 94-
310262-3010LF is supplied with earlier SF-3050
production units. P/N 94-310274-3010LF is supplied
with later SF-3050 production units.
Refer to Chapter 3/Event for detailed electrical
specifications.
Table 29 details the wiring configuration required for
Event pulse sensing.
Figure 85: Event Cable Wiring Diagram
Table 29: Event Wiring Connections
Pin #
Signal
Name
Event Sync Wiring
3 Event Tie Event to Ground
9 Ground N/A
Once the cable is wired to correspond with the event
pulse requirements, configure the receiver to output
the message containing a time mark
– referenced to
the time kept within the receiver indicating when the
event is sensed (EVENTLATCH, EVENTLATCHA).

The EVENTLATCH and EVENTLATCHA
messages are described in the Sapphire