NavCom SF-3050 Rev.E - Manual (Page 151)

SF-3050 GNSS Product User Guide
– Rev E
5-125
1. On the Input Terminal, type [SFNETPRIORITY] to
view the current priority net settings.
2. Perform one of the following:
Type [SFNETPRIORITY]DEFAULT to
command the system to automatically select
the StarFire satellite with the highest elevation
angle, regardless of Net1 or Net2, but subject
to authorized nets.
Type [SFNETPRIORITY]NET1
1
to set Net1 as
the priority net, which commands the receiver
to select the Net1 StarFire satellite with the
highest elevation angle.
Type [SFNETPRIORITY]NET2
2
to set Net1
as the priority net, which commands the
receiver to select the Net2 StarFire satellite
with the highest elevation angle.

1
If there are no visible Net1 satellites,
or if the receiver is licensed as Net2
only, the receiver will select the Net2
StarFire satellite with the highest
elevation angle.

2
If there are no visible Net2 satellites,
or if the receiver is licensed as Net1
only, the receiver will select the Net1
satellite with the highest elevation
angle.

Refer to the Sapphire Technical
Reference Manual for detailed
information on the [SFNETPRIORITY]
command.