Factory default output messages, Table 22: factory default nct messages/responses – NavCom SF-3050 Rev.E User Manual
Page 143
SF-3050 GNSS Product User Guide
– Rev E
5-117
The user has full control over the utilized
message types and their associated
rates via either
StarUtil 3000 or a third-party
software/utility.
Factory Default Output Messages
NCT Messages
Table 22: Factory Default NCT Messages/Responses
Output on Ports COM1 and USB1
Message
Rate
Description
ALM1B
On Change
Satellite Almanac
CHNLSTATUS1B
On Time 1Hz
ASIC & StarFire Channel
Status
EPHEM1B
On Change
Satellite Ephemeris
MEAS1B
On Time 1Hz
Raw Satellite Measurement
Data
MSGPRODUCTINFO
On Time 600 Sec
Product Type, Digital Serial
Number, and System
Revision Number
MSGVERSION
On Time 600 Sec
Firmware Identification Block
PVT1B
On Time 1Hz
Position, Velocity, and Time
(PVT) Solution
PANICA
On Change
Factory Use
Output on All Ports
Message
Rate
Description
OK (mnemonic)
On Change
Ack (“Acknowledged”).
Ack indicates a successful
input message operation.
?? (mnemonic)
{argument error}
On Change
Nak (“Not Acknowledged”).
NAK indicates a failure in
executing a command.
PANICA
On Change
Factory Use