Microcom 438 - Manual (Page 56)

Chapter 5 Printer Commands
438 Operator’s Manual - 880052-0100 5-9
2 External Print Request: (Call Microcom for more information.)
1 = Enable
0 = Disable
3
Stock Out function: Enable this function to get a >LOW STOCK<
message when the printer runs out of stock. When this is disabled, the
printer will not report stock out conditions.
1 = Disable
0 = Enable (stock out detection reports >LOW STOCK<)
4
Auto-size on Power-up: When enabled, the printer automatically sizes
the label to determine the appropriate format header values on power-
up. The printer will then use these values on all subsequent label
formats. Refer to the ^D39 command for additional information.
1 = Enable
0 = Disable
5,6,7,8 Code Page Selection: Positions 5 through 8 are used to select from
the available code pages stored within the printer.
See Chapter 9 for more details
0000 = Not Decoded (Default)
0001 = Danish
0010 = 860
0011 = Spanish
0100 = 850
0101 = German
0110 = 865
0111 = Swiss
1000 = 852
1001 = French
1010 = 863
1011 = Swedish
1100 = 437
1101 = Italian
1110 = English - UK
1111 = English – US
5.2.1.5
Software Switch #5
^AB ^D
COMMAND
XX 25 Change SW5: Software Switch #5.
^AB12345678 (each bit is represented by a numeric position number)
Position:
1 Single Button Press Error Clear: If enabled, error conditions are cleared
with a single press of the print button after reloading the printer with more
media.