Microcom 438 - Manual (Page 116)

Chapter 7 Downloadable Fonts
438 Operator’s Manual - 880052-0100 7-7
7.6 Downloadable Font Command Summary
The following commands refer to the use of downloadable fonts and graphics:
^A
^D COMMAND
100 Clear User RAM: This command clears all downloadable fonts, graphics, and
stored label formats.
101 List Memory Bytes Available: The printer will send the “>” character
followed by the amount of available bytes and then finally a “<” character
(>192690<).
XX
104 Load GRAPHIC or FONT into RAM Memory without Compression:
The ^Axx specifies which memory slot to place the image/font (1-255). This
command should be used with an ASCII-HEX file that contains only printable
characters less than 80 HEX. This command supports GRAPHICS over
64KB.
XX
106 Load GRAPHIC or FONT into RAM Memory without Compression:
This command is intended for legacy support only and Microcom Corporation
recommends either the ^D104 or ^D107 commands.
Fonts must be less than 64KB for this command to function.