Mounting the machine torch -38, Torch alignment -38, Mounting the machine torch – Hypertherm HT4001 Plasma Arc Cutting System User Manual
Page 91: Torch alignment

INSTALLATION
4-38
HT4001
Instruction Manual
Mounting the Machine Torch
1. Install the machine torch (with torch leads attached) in the torch mounting bracket without IHS probes
(Fig. 4-21) or the alternate torch mounting bracket (Fig. 4-20) if IHS is used.
2. Position the torch until the torch body extends all the way through the bracket, so that the bracket is now
around the plastic torch sleeve and not touching the stainless steel torch body. Position the torch approximately
.25 " (6 mm) from the workpiece.
3. Tighten the securing screw(s). See Pre-Operation in Section 5 for final adjustment of torch.
Torch Alignment
To guarantee the torch is at right angles to the workpiece, align the torch with a square at 0° and 90°.
See figure 4-21.
Figure 4-21
Torch Alignment (without IHS probes)
Figure 4-20
Mounting the Machine Torch
(with IHS probes)
Torch leads
(typical)
Torch sleeve
Torch mounting
bracket
Workpiece
0°
90°
Securing
screw
Securing screws
Torch sleeve
Torch mounting
bracket
.25" 6 mm