FSR RN-8200 User Manual
Page 41
3.0 Configuration Utility Software
RN-8200 Reference Manual
Page 3-20
# ITEM
DESCRIPTION
7
Scripting Scratch
Pad Controls
The scratch pad provides a way to copy and paste commands. It can be used as a way to
avoid having to create new commands if they are merely minor changes to commands
already in your script. It can also be used to copy and paste commands between buttons.
Copy Button:
This copies the highlighted command from the scripting window into the scratch pad.
Cut Button:
This cuts the highlighted command from the scripting window into the scratch pad.
Scratch Pad Window:
This shows the commands currently available in the scratch pad.
Paste Button:
This pastes the highlighted command from the scratch pad to the scripting window.
Trash Button:
This deletes the highlighted command from the scratch pad.
Note: This element of the Serial Command works in same way as the corresponding
element on the overall Button Command Configuration panel.
# ITEM
DESCRIPTION
8
Clear All Serial
Commands Button
This button deletes all portions of the serial command from the scripting window (or clears
the command script).
Note: This element of the Serial Command works in same way as the corresponding
element on the overall Button Command Configuration panel.
# ITEM
DESCRIPTION
9
Serial Command
Configuration
Controls
These controls decide if you want to save the configuration for the button or cancel it and do
something else.
Note: This element of the Serial Command works in same way as the corresponding
element on the overall Button Command Configuration panel.
3.2.8.5 Configuring an IR Playback Command
The IR Playback Command allows the user to
create commands that will control IR connected
devices by playing back the learned IR
commands stored in the Room Navigator IR
command library. The IR Address Location is a
pull down for selection of one of the 61 possible
IR command locations. The IR Port identified
the IR output port to which the command will be
sent. The command can be repeated up to 99
times using the Repeat option at the bottom of
the entry panel. Once the IR Playback Command
is configured as needed, click the “Ok” button to
build the final formatted command in the main
Button Command Configuration panel. The IR
Playback Command Entry panel is shown to the
right.