FSR RN-8200 - Manual (Page 24)

3.0 Configuration Utility Software
RN-8200 Reference Manual Page 3-3
7 S-Video
8 S-Video
Mode.
Note: It is recommended that you use the CU and examine how these buttons
are configured
The Figure below shows the commands configured in the Default file for the “System Operational / Idle” Toggle
Button (the upper leftmost Room Control Button):
This command is the “Set Operational” Command which
sets the internal state to operational and activates the
system to respond to button presses from connected panels .
This command is a
“Button Press” Command
that is essentially the
same as pressing the
Source Select 1 button.
It is used to establish
source 1 as active when
the system starts . Note
also that this command
will result in executing
any commands
configured into the
Source Select 1 button.
This command is the “Set
Idle” Command which
sets the internal state to
idle and stops the system
from responding to button
presses from connected
panels.
3.2.3.2 “Device” Functions
The “Device” functions are actions that either “Get”
data from, or “Send” data to, the connected Room
Navigator device. All of these “Device” actions can
also be executed using buttons that appear on the
various tabs in the CU and this menu item is just
repeat of all the data interchange actions with the
device in one place.
Since these functions require a connected device,
when you are working offline, this menu item is
deactivated. Each action in the sub-menu selections
identifies the specific type of data involved (IR,
Notes, or Button Data) or all of the data.