FSR RN-8200 - Manual (Page 39)

3.0 Configuration Utility Software
RN-8200 Reference Manual Page 3-18
3.2.8.4 Configuring a Serial Command
The Serial Command allows the user to create commands that will control devices using the CM RS-232 Ports.
After selecting a Serial Command from the Command Type List in the Button Configuration screen, the Serial
Command Configuration Panel will open as shown below.
1
2 6
5
4
8
9
7 3
# ITEM DESCRIPTION
1 Serial Port Selection This allows you to identify the control port where this serial data string will be sent when the
command is executed in operation.
# ITEM DESCRIPTION
2 Raw Data Entry
Options These selections allow you to select the data format to enter raw data for the command
string. The data can be a mix of ASCII and Hex in any combination, entered in any order,
and switching back and forth as much as needed. All data entered is shown in the Serial
Data Window (item 4) in the order it was created. When one of these buttons is pressed, the
corresponding data entry panel opens (see below) to allow you to enter the data in the
format selected.