FSR RN-8200 - Manual (Page 36)

3.0 Configuration Utility Software
RN-8200 Reference Manual Page 3-15
1
2
3
6
5
4
8
9
7
# ITEM DESCRIPTION
1 Button Map The small “button map” graphic and text is provided in the upper left corner to identify the
particular button being configured. The button being configured is highlighted in green. Note
that when a function button is being configured, there will be 2 buttons highlighted in green,
one to identify the “Device” (or source) and one to identify the “Function”. Several examples
of the button map are shown below.
2 Command Type List The Command Type List shows the types of commands that can be configured to control the
equipment in the user’s application. These commands can be configured for a button in any
combination desired as single commands or in a sequence of commands. To configure any
given command type, you can use the mouse and “drag-and-drop” the command from the
list into the command script window (# 4), or you can highlight the command in the list and
click the “Insert Command” button located below the list. Each command type is described in
detail later in the subparagraphs that follow.
3 Special Button
Attributes Special Button Attributes are as follows:
Toggle Check Boxes:
This feature allows configuration of a different command or command set to be configured
for execution on either Odd/Even button presses or when the button is pressed and
released. This feature is not applicable to virtual buttons.
Auto Repeat Check Box:
This feature allows configuration of auto-repeating commands that will repeat as long as the
button is pressed. When checked, the “Delay” will become active so that a delay between
repeats can be assigned if desired. The default delay between repeats is 0.00 seconds. This
feature is not applicable to virtual buttons.