FSR RN-8200 - Manual (Page 38)

3.0 Configuration Utility Software
RN-8200 Reference Manual Page 3-17
The Audio Mute Toggle Command will now
appear in the command script window as
shown to the right.
To save this configured button, click “Ok”
again on the Button Command Configuration
panel. The CU will ask “Do you want to
program this button now?” Click Yes to
program the button or No to do it later. If you
click that button again, you’ll see that the
Button Command Configuration Panel opens
with the already configured command
showing in the Command Script Window.
Note: Once you become more familiar with
the CU, you may want to select the
automatic option for configuring the
RN as button configurations are
made in the CU. This automatic
option is accessed using the
“Options” item form the menu bar
and checking the corresponding box
as shown below.
3.2.8.3.2 Example 2: Configuring a with an Even/Odd Toggle Command
Select another button from the Room Control Area of
the panel. Then check the box beside “Even/Odd
Toggle. The Command Scripting Window will split
into a top and bottom section. The top is now the
“Even” button-press command script and the bottom
is the “Odd”. This means whatever command or
command sequence you put in the top area, will
execute on even presses of the corresponding button.
Similarly, whatever you put in the bottom will
execute on odd button presses. The Press/Release
toggle works in a similar manner except the top area
represents the command(s) that will execute when
the button is pressed and the bottom area represents
the command(s) that execute when the button is
released. The figure to the right shows an example
of an Even/Odd configuration. For this example, on
Even presses, Relay 1 is toggled then the RN waits
0.5 seconds then toggles Relay 1 again. On Odd
presses, Relay 3 is toggled then the RN waits 2
seconds then toggles Relay 3 again.