Epiphan VGA Printer - Manual (Page 58)

5. Advanced Printer ConfigurationAdding a Printer That the VGA Printer Device Cannot Find Au-
Page 58 Epiphan VGA Printer
This section contains two procedures. You can use the first one,
“Adding a Printer Manually” on page 58 , if the VGA Printer
device can’t find a printer that you want to add. You can use the
second procedure, “Adding a Printer Using a PPD File” on
page 64 , if the VGA Printer device can’t find a printer that you
want to add and you have a PPD file for that printer or if you
would like to attempt to get a PPD file for that printer.
Adding a Printer Manually
Use the following procedure to manually add a printer. Before
you start this procedure you should know the following:
• The name and manufacturer of the printer.
• If the printer is connected to a network, the network protocol
used by the printer (see “Network Protocols Supported By the
VGA Printer device” on page 75 ).
To add a printer manually
1 Log into the Web admin interface.
2 Scroll down to the Configure VGA Printer section.
3 Select Printers configuration and jobs control.
You may have to enter the admin username and password.
The Printers page appears.
Figure 26:Printers page (no printers added)