Epiphan VGA Printer - Manual (Page 20)

2. Installation and Getting Started If the Network Doesn’t Have a DHCP Server
Page 20 Epiphan VGA Printer
• To add a new printer, see “Adding Printers” on page 27 .
• To set a printer to be the default printer, see “Selecting the
Default Printer” on page 68 .
If a printer is turned off or disconnected, VGA Printer may store
print jobs in that printer’s print queue. When the printer is
connected or turned on again, the stored print jobs will be
printed. After the printer is restarted you may have to go to the
print queue and restart print jobs for them to print. See
“Controlling Print Jobs” on page 70 for information about
viewing and starting print jobs.
If the Network Doesn’t Have a DHCP
Server
If the network doesn't have a DHCP server, to log into the VGA
Printer Web admin interface you need to temporarily change the
network configuration of your PC.
You must also establish an ethernet connection between the VGA
Printer device and your PC. You can do this one of the following
ways:
• Connect the VGA Printer ETH 1 port to the same Ethernet
network as your PC.
• Connect the VGA Printer ETH 1 port to an Ethernet network
switch and connect your PC’s Ethernet port to the same
switch.
• Connect the VGA Printer ETH 1 port directly to your PC’s
Ethernet port using a cross-over cable.