Epiphan VGA Printer - Manual (Page 24)

2. Installation and Getting Started If the Network Doesn’t Have a DHCP Server
Page 24 Epiphan VGA Printer
Figure 9: Example VGA Printer IP address configuration change
6 Confirm that the settings are correct and select Continue.
7 Scroll down the Web admin interface to the Reboot the
system section and select Reboot. Then select Continue.
It takes a few minutes for the VGA Printer device to reboot.
8 After a few minutes try logging into the VGA Printer Web
admin interface by browsing to the new IP address. For
example, browse to:
http://192.168.1.20
9 Enter the Web admin interface user name and password to
login.
To reset network settings to use DHCP
By default, if you connect the VGA Printer device to a network
with a DHCP server, the DHCP server will automatically
configure the VGA Printer network settings. If required you can
disable DHCP settings to use a static IP address. This procedure
describes how to re-enable DHCP settings that have been
disabled.
1 Log into the VGA Printer Web admin interface.
2 Scroll down to Change IP Address.
You can also use your web browser find feature to find
Change IP Address.
3 Change How to obtain IP address to Use DHCP.
4 Select Continue.
5 Scroll down the Web admin interface to the Reboot the
system section and select Reboot. Then select Continue.
It takes a few minutes for the VGA Printer device to reboot.