Epiphan VGA Printer - Manual (Page 45)

4. VGA Printer Web admin interface Using the VGA Printer device as a DHCP Server
User Guide Page 45
Using the VGA Printer device as a DHCP
Server
You can configure the VGA Printer device to act as a DHCP
server on the network. To configure the VGA Printer device to act
as a DHCP server, enable the DHCP server on the device and
enter the range of IP addresses that the DHCP server can provide.
You might want to configure the VGA Printer DHCP server if the
network you are connecting your the VGA Printer device to does
not have a DHCP server and you want to automatically set the IP
addresses of the some of the devices on your network using
DHCP.
To enable the VGA Printer DHCP server
1 Log into the Web admin interface.
2 Scroll down to the DHCP Server section.
Figure 22:DHCP server
3 Select Run DHCP Server.
4 Enter the Start and End addresses of the IP address range that
the DHCP server can assign to devices on the network.
5 Select Change DHCP Server Configuration.
6 Scroll down to Reboot the system.
7 Scroll down the Web admin interface to the Reboot the
system section and select Reboot. Then select Continue.
It takes a few minutes for the device to reboot and resume
operation with the new DHCP server configuration.