Epiphan VGA Printer - Manual (Page 41)

4. VGA Printer Web admin interface Configuring the Ethernet Bridge For Use if You Have Only
User Guide Page 41
5 Scroll down the Web admin interface to the Reboot the
system section and select Reboot. Then select Continue.
It takes a few minutes for the device to reboot.
6 Connect ETH 1 directly to the PC using a cross-over or regular
Ethernet cable.
7 Connect ETH 2 to the network.
Figure 20:Connecting a network and a PC to the VGA Printer
device
Connecting a Network Printer Directly to the
VGA Printer ETH 2 Port
You can use the following procedure to connect a supported
network printer directly to a VGA Printer Ethernet port. Usually
you would connect the printer to the ETH 2 port and keep the
ETH 1 port available for connecting a PC or for connecting the
VGA Printer device to a network.
VGA
Cable
ETH 1
ETH 2
PC
VGA source
Ethernet
Network