Comtech EF Data CMR-6000 Manual - Manual (Page 37)

Digicast Media Router S2 Receiver CMR-6000 Revision 1
Device Management via User Interfaces MN-CMR6000-IOM
4-7
4.2.3 Vload Configuration
Vload is a system used to remotely update the CMR-6000 receiver via multicast transmission. Please refer
to the Digicast section of the Vload manual for information on how to use the head-end software
component of Vload.
IP Address
The multicast address to be used for Vload.
Please note that the multicast addressed used here should not be used in any other route settings.
PID
Define the PID value (in hexadecimal format) to use for Vload.
Note: This PID value cannot be used or defined elsewhere on this receiver for carrying user data traffic.