Introduction, B.1 introduction – Comtech EF Data MiniMAC Operation ManualOperation Manual Operation Manual User Manual

Page 28

Text mode
Original mode

Configuring Alarms

MiniMAC Rack Management System

B–2

Rev. 0

B.1 Introduction

The alarms setting is set to a default beep condition. When a fault, alarm, or
communication alarm condition is detected, the system will flash RED, YELLOW, or
ORANGE (depending on condition) and sound the default beep wave file.

The user can turn the sound off, then set the alarm condition to play a pre-determined
wave file. When the ENABLE line has been checked, click on Setup Sound.