Comtech EF Data MiniMAC Operation ManualOperation Manual Operation Manual - Manual (Page 129)

MiniMAC Rack Management System SDM-300 Modem Screens
Rev. 0 6–9
To Acknowledge a new flashing fault, proceed as follows:
Command Response
Click on Faulted parameter acknowledge field. The fault stops flashing.
To Clear stored faults, proceed as follows:
Command Response
Click on CLEAR STORED FAULTS (Fault Screen)
Observe NUMBER OF STORED FAULTS go to 0.
To Disable backward alarms, proceed as follows:
Command Response
Click on Mask (in the BACKWARD ALARMS area)
Observe The interface TX and Interfaces Rx Summary Alarms turn GREEN..