Comtech EF Data CRS-400 - Manual (Page 71)

CRS-400 1:8 Redundancy Switch Revision 0
Remote Control MN/CRS400.IOM
55
A.6 STORE/LD (S
TORE OR
L
OAD
C
ONFIGURATION
)
STORE/LOAD CONFIG:
STORE LOAD (PRESS ENTER)
Select STORE or LOAD using the LEFT/RIGHT arrow keys, then press ENTER.
The switch can store up to 10 different switch configurations in non-volatile memory.
These are configurations for the switch itself, not the modems attached to it. Switch
configurations contain the information for active units, bridge/backup units, backup
holdoff, restore holdoff, etc. For more information, see the
Switch Global Configuration
remote command in Section B.6, Remote Control Commands .
A.6.1 (STORE/LD) STORE
STORE CONFIGURATION TO
LOCATION: 10 (ENTER)
Select the location to store the current configuration to, using the UP/DOWN arrow keys,
then press ENTER.
Available Locations:
1 2 3 4 5 6 7 8 9 10
If the selected location does not contain a previously stored configuration, the following
screen is displayed:
YOUR CONFIGURATION HAS
BEEN STORED! (ENTER)
To return to the previous menu, press ENTER or CLEAR.
If, however, the selected location contains a previously stored configuration, the
following screen is displayed:
WARNING! LOC 10 CONTAINS
DATA. OVERWRITE? NO YES
Select NO or YES using the LEFT/RIGHT arrow keys, then press ENTER.
Selecting YES will overwrite the existing configuration at the selected location.