Comtech EF Data CRS-400 - Manual (Page 67)

CRS-400 1:8 Redundancy Switch Revision 0
Remote Control MN/CRS400.IOM
51
A.4 INFO (I
NFORMATION
)
INFO: SWITCH-ID SETUP
IF-SWITCH REMCONT MASK
Select an INFO parameter to view, using the LEFT/RIGHT keys, then press ENTER.
INFO screens display information on the current configuration of the switch without
risking inadvertent changes.
A.4.1 (INFO) SWITCH-ID
SWITCH ID:
THIS IS A TEST MESSAGE
This displays the user-defined Switch ID string, which is entered via the UTILITY,
SWITCH-ID screen. To return to the previous menu, press ENTER or CLEAR.
A.4.2 (INFO) SETUP
MOD:123---78 DE:12-------8
AUTO:OFF BH:05 RH:20 IND
The information on this screen reflects some of the settings configured in the CONFIG,
OPTIONS menu. Active traffic mods/demods are listed on the top line, while Auto mode,
times for Backup Holdoff and Restore Holdoff, and Independent or Dependent mode are
listed on the bottom line.
A.4.3 (INFO) IF-SWITCH
IF-SWITCH IS ABSENT
Or
IF-SWITCH IS PRESENT
This screen shows whether an IF Transponder Switch is connected to the CRS-400 1:8
Redundancy Switch. When an IF switch is present, the CRS-400 does not exert transmit
IF control for an offline mod, the IF switch manages that. There are two models of IF
switch: CRS-280 (70/140) and CRS-282 (L-band).