Comtech EF Data CRS-400 - Manual (Page 63)

CRS-400 1:8 Redundancy Switch Revision 0
Remote Control MN/CRS400.IOM
47
A.3.4.2.3.1 (CONFIG, REM, SETTINGS, TYPE) RS232
IN RS232 MODE THE BUS
ADDRESS IS FIXED AT 0000
However, if either RS485 mode is selected, you may edit the bus address:
A.3.4.2.3.2 (CONFIG, REM, SETTINGS, TYPE) RS485
EDIT SWITCH BUS ADDRESS:
3000 (PRESS ENTER)
To edit the RS485 bus address of this unit:
1 Change the value of the address using the UP/DOWN arrow keys.
2 Press ENTER.
The only permitted addresses are:
1000 2000 3000 4000 5000 6000 7000 8000 9000
A.3.5 (CONFIG) OPTIONS
OPTIONS: MASKS MODE[IND]
HOLDOFFS RESTORE-TIME
Use OPTIONS to select mode and masks, affecting how the switch will react to various
faults.
A.3.5.1 (CONFIG, OPTS) MASKS
ALARM MASK: MODEM-ALARMS
SW-ALARMS AUDIO (ENTER)
The switch logs and reacts to its own faults and mod/demod faults. Use this sub-menu to
mask any of these fault types, and to enable or disable an audible indicator (buzzer).
A.3.5.1.1 (CONFIG, OPTS, MASKS) MODEM ALARMS
MODEM ALARM MASK: NONE
MOD DMD BOTH (ENTER)
Use this option to mask traffic faults for MOD (Tx), DMD (Rx), or BOTH, so that the
switch will not react to them. Select one of the four options: NONE, MOD, DMD, or
BOTH.