Beisler 100-68 - Manual (Page 91)

3.2 Switching the seam functions on/ off
The parameter values are altered in the individual parameter screens.
– Tap the desired parameter.
The symbol of the selected parameter is framed in blue.
– Tap the OK key.
The function is switched on/off or a window with the prompt or the
current values appears.
– Alter the parameters as described under 1. to 4.
– Tap the OK key once again.
The new setting of the parameter value is taken over.
When altering the parameter values it is necessary to distinguish
between four parameter groups:
1. Functions which are switched on or off
–
Tap the function of the parameter to switch it on or off.
(on) (off)
2. Parameters with various functions
–
Set the desired function of the parameter by tapping the cursor
keys “
ð ” or “ï”.
3. Parameters the values of which are altered in steps
–
Select the previous or next step of the parameter value by tapping
the cursor keys “
ñ ” or “ò”.
4. Parameters the values of which are entered via the numeric
keypad
–
Enter the desired parameter value via the numeric keypad.
ATTENTION !
The value must be within the given limits.
If the value entered is too large or too small, the upper or lower
limit is displayed after pressing the enter key.
4
7