Beisler 100-68 User Manual
Page 103
17 Engaging the centre knife
According to the seam and knife width the centre knife should make an
approx. 1 mm longer cut than the corner knife at the seam beginning.
Input:
0 - 30 mm
Factory setting:
10 mm
18 Disengaging the centre knife
According to the seam and knife width the centre knife should make an
approx. 1 mm longer cut than the corner knife at the seam end.
Input:
0 - 30 mm
Factory setting:
8 mm
19 Thread monitor on after
Seam section after which the thread monitor is activated;
alter the parameter for sewing lengths < 30 mm.
Input:
0 - 99 mm
Factory setting:
80 mm
Set the value to 10 for pocket lengths under 40 mm.
20 Thread monitor filter
The smaller the number, the more sensitive the needle thread monitor
will react.
Input:
0 - 99
99 = Thread monitor deactivated
Factory setting:
07
21 Fleece length at the seam beginning
Via this parameter the fleece projection at the seam beginning is set.
Input:
0 - 99 mm
Factory setting:
20 mm
22 Fleece length at the seam end
Via this parameter the fleece projection at the seam end is set.
Input:
0 - 99 mm
Factory setting:
20 mm
23 Duration of ejector roller rotation
Via this parameter the precise positioning of the workpiece for the
subsequent stacking operation is set.
Input:
0 - 99 sec
Factory setting:
0.5 sec
19
4